User Manual
Basic Trouble-Shooting
Plug order - First connect power then connect USB. Unplug it and plug it back it.
-----
Check in MOSA - With the device powered off click Serial and select the CP2102. Wait about 15 seconds and turn on the device. It should home. If it does move the sliders and watch the visualizers and compare it to the devices movements this will help you identify if there is a direction problem with the servos.
-----
Servo Motion Inverted - OSR2: Check that SR6 mode not enabled in web panel settings. Switch (literally swap) the digital servo leads(orange wire). Normally white or orange. (The wires themselves remove from the connectors they are in by lifting a small plastic tab).
Servo Motion Inverted - OSR2: Check that SR6 mode not enabled in web panel settings. Switch (literally swap) the digital servo leads(orange wire). Normally white or orange. (The wires themselves remove from the connectors they are in by lifting a small plastic tab).
-----
Servo Motion Slow Sluggish Not In Sync - Wrong voltage/No power/Bad Sevo- Check cords and power barrel for good connection.
-----
Erratic Behavior - Check that the ground cable between power bus and ESP32 chip has a good connection. )Connects the ground side of power-bus and the ESP32.)
Erratic Behavior - Check that the ground cable between power bus and ESP32 chip has a good connection. )Connects the ground side of power-bus and the ESP32.)
Where You Can Reach Out For Assistance
TempestMAx Discord Sever (Will need to be subscribed to TempestMAx Patreon)
-----
Discord - M0$AIC#0338
Discord - M0$AIC#0338
-----
Email - yourhobbiescustomizedllc@gmail.com
Email - yourhobbiescustomizedllc@gmail.com
------
Please Support TempestMAx
TemepestMAx Patreon - https://www.patreon.com/tempestvr/posts (Please Subscribe)
